Preliminary Work

Information 

The convertible top must be moved to various positions in order to gain the best possible access to the fitting areas shown below.

Information 

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Remove three-point seat belt deflection fitting. →  691119 REMOVING AND INSTALLING FRONT THREE-POINT BELT 
2. Remove rear wall trim panel. →  Removing trim panel for rear wall 
3. Loosen the roll-over bar. →  Removing Roll-Over Bar 
4. Detach bowden cable. →  Removing Lower Part Of Valve