Sealing the sealing surface of the cylinder head cover: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Use only the sealant

Drei Bond silicone - Type 1209 and Loctite 5900

--- to seal the sealing surface on the cylinder head cover.

NOTE:

After the sealant has been applied, the cylinder head must be joined with the cylinder head cover within 5 minutes.