LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine - 911 CARRERA (996)) >> Removing and installing solenoid hydraulic valve >> Preliminary work: Removing and installing camshafts - engine removed >> Removal

Preliminary work: Removing and installing camshafts - engine removed: Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove solenoid hydraulic valve.
    NOTE: Install the solenoid valve only if the VarioCam tensioning element is vertical. Correct seating of the compression spring (No. 4) is no longer ensured if the solenoid hydraulic valve is installed horizontally (installation position of engine).
  2. Undo self-tapping screws (Torx T 20) No. 1.
    NOTE: Mark a threaded screw and threaded bore for reinstallation.
  3. Remove solenoid valve. Leave valve plunger and compression spring in installation position.
scientia non olet · About LEMON Manuals