Removing and installing oil protection tubes - Engine installed: Tools: Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
INSTALLATION PROCEDURE - OIL PROTECTION TUBES
| No. | Procedure | Instructions |
|---|---|---|
| 5 | Pull off oil protection tube | Fit washer (approx. 40 mm "PHI" ) and hexagon nut (M10) on the threaded rod. Press oil protection tube outward using two mounting levers, always using a suitable wooden support. |
| 6 | Fit oil protection tube | Fit new sealing rings and coat with tyre mounting paste. Using the pressure piece (special tool 96051/1) and hand pressure piece (special tool 9604), manually press in the oil protection tube as far as it will go. |
| Fit spark plug | Fit spark plug with the prescribed spark-plug wrench. Tighening torque 25 +/- 5 Nm (19 +/- 3.5 ftlb.) | |
| Fit ignition coil | Tightening torque 10 Nm (7.5 ftlb.) |