Engine accessories
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Install engine accessories in the reverse sequence to that in which they were removed. Some additional instructions follow.
- Spark plugs:
Tightening torque for old spark plugs: 25 Nm (19 ftlb.) Tightening torque for new spark plugs: 30 Nm (22 ftlb.)
- Hall sender: use 2 new M6 micro-encapsulated pan-head screws (hexagon socket a/f 5).
Tightening torque 10 +/- 0.5 Nm (7.5 +/- 0.5 ftlb.)
- Exhaust manifold: use new M8 x 28 hexagon-head bolts.
Tightening torque: 23 Nm (17 ftlb.)
- Holder for coolant ventilation: replace 1 M6 x 16 (micro-encapsulated).
Tightening torque 10 Nm (7.5 ftlb.)
- Speed sender: replace 1 M6 x 16 (micro-encapsulated).
Tightening torque 10 +/- 0.5 Nm (7.5 +/- 0.5 ftlb.)
- Intake pipe support: install with 4 M6 x 35 hexagon-head bolts and new sealing rings.
Tightening torque 10 Nm (7.5 ftlb.)
- Intake distributor: install with 6 new M6 x 35 micro-encapsulated hexagon-head bolts and new molded seals on intake pipe support.
Tightening torque 10 Nm (7.5 ftlb.)
- Generator: tighten M8 hexagon nut for B+ cable to the specified torque.
Tightening torque 15 Nm (11 ftlb.)