Removing and installing centre console
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Illustrated on the 911 Turbo (996)
NOTE:
- Before removal, the centre console must be partly disassembled. For this purpose, remove both the front covers and the front trim. See REMOVING AND INSTALLING CENTRE CONSOLE (FRONT SECTION) .
CENTRE CONSOLE REMOVAL/INSTALLATION PROCEDURE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Shift lever knob | 1 | Disengage from the clips -2-1- . See Fig 2 . | Push on. |
| 2 | Clip | 4 | Inspect and replace if necessary. | |
| 3 | Fastening screws | 3 | Undo. | Screw in. |
| 4 | Ashtray insert | 1 | Lift out. | Press in. |
| 5 | Expanding nut | 2 | Press out. | Press in. |
| 6 | Ashtray retaining bracket | 1 | Unclip the ashtray retaining bracket -6- . See Fig 2 . | Connect the electrical plug connections, secure the ashtray retaining bracket -6-3- . See Fig 2 . |
| 7 | Rubber insert | 1 | ||
| 8 | Floor oddments tray | 1 | Undo fastening screw -3-8- . See Fig 2 . | Position the floor oddments tray -8-3- . See Fig 2 . |
| 9 | Coin box | 1 | Unclip the coin box -9-3- . See Fig 2 . | Tighten the fastening screw -3-9- . See Fig 2 . |