Removing and installing centre console (front section)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
CENTRE CONSOLE (FRONT SECTION) REMOVAL/INSTALLATION PROCEDURE
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Cover, front left | 1 | Unclip the front left cover -1- . See Fig 2 . | Position the front cover -1-15-3- . See Fig 2 . |
| 2 | Cover, front right | 1 | Unclip the front right cover -2- . See Fig 2 . | Position the front cover -2-15-3- . See Fig 2 . |
| 3 | Clip | 10 | Inspect clip -3- . See Fig 2 . | |
| 4 | Cover cap (telephone trim panel) | 1 | ||
| 5 | Fastening screw | 9 | ||
| 6 | Telephone trim panel | 1 | Insert a wire into the hole of the cover cap -4-5-8- . See Fig 2 . | Insert the locking tabs of the telephone trim panel into the front cover -8-5-2.3 Nm (1.5 ftlb.)-4- . See Fig 2 . |
| 7 | Installation frame for (telephone handset) | 1 | ||
| 8 | Cover, front left (telephone carrier) | 1 | Unscrew fastening screws -5- . See Fig 2 . | Position cover at the centre console at the front, clip in at the side and fasten with the fastening screws -5-2.3 Nm (1.5 ftlb.)- . See Fig 2 . |
| 9 | Adapter | 1 | Unscrew fastening screws -5- . See Fig 2 . | Position the adapter at the centre console at the front -9-5-2.3 Nm (1.5 ftlb.)- . See Fig 2 . |
| 10 | Combi-single CD drive for navigation | 1 | See: REMOVING AND INSTALLING NAVIGATION UNIT . | |
| 11 | Heating/air-conditioning control | 1 | See: REMOVING AND INSTALLING HEATING/AIR-CONDITIONING CONTROL . | |
| 12 | Front trim | 1 | Unclip the front trim -12- . See Fig 2 . | Connect the electrical connection, position the front trim -12-15- . See Fig 2 . |
| 13 | Cover, left | 1 | Unclip the left cover -13- . See Fig 2 . | Position the right cover -13-3- . See Fig 2 . |
| 14 | Cover, right | 1 | Unclip the right cover -14- . See Fig 2 . | Position the right cover -14-3- . See Fig 2 . |
| 15 | Centre console (front section) | 1 | Undo fastening screws -5-15- . See Fig 2 . | Position the front of the centre console -15-18-5- . See Fig 2 . |
| 16 | Plug-in nut | 4 | Inspect and replace if necessary. | |
| 17 | Collar nut | 4 | Tightening torque: -10 Nm (7.5 ftlb.)- | |
| 18 | Holder | 1 |