Adjusting the rear side section trim

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Adjusting Gap Dimensions Of Rear Side Section Trim

Courtesy of PORSCHE OF NORTH AMERICA, INC.

(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The height adjustment is made using the fastening screws -D1- in the flap. See Fig 1. See TEST AND ADJUSTMENT VALUES .

Set the gap dimension -D- rear side section flap to the side trim panel. See Fig 1. See TEST AND ADJUSTMENT VALUES .
Set the gap dimension -E- rear side section flap to the side trim panel. See Fig 1. See TEST AND ADJUSTMENT VALUES .
Set the gap dimension -F- rear side section flap to frame trim panel for the roll-over protection system. See Fig 1.
See TEST AND ADJUSTMENT VALUES .