Converting holder for hydraulic pump (Cabriolet): Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Convertible top in service position.
See REMOVING AND INSTALLING CONVERTIBLE TOP .
Removing hydraulic pump
Remove hydraulic pump with holder. See REMOVING AND INSTALLING HYDRAULIC PUMP .
Sawing off holder
Saw off holder -1- from bracket -2- using a saw blade and saw blade holder -3- . See Fig 1.

Fig 1: Sawing Off Holder (Cabriolet)
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Enlarging through hole in bracket
Enlarge through hole -4- in bracket -2- for correct fitting of fastening screw using a twist drill 6.0 mm -5- . See Fig 2.

Fig 2: Enlarging Through Hole In Bracket (Cabriolet)
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Installing new hydraulic pump
Install hydraulic pump. See TIGHTENING TORQUES .