Installing guide for fabric lining
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Press in electrical wire into the guide for fabric lining at the side. Begin at the marking (white point) on the wire. Connect the plug connection.
- Position guide for fabric lining -2- on inner roof module, screw in fastening screws -1- . See Fig 1.
- Set the adjusting dimension -60 mm-
for the fabric lining guide and the roof module guide using the distance gauge. See Removing guide for fabric lining -3-
. See Fig 1.
See Test and adjusting values .
See Tools and materials .
- Tighten the fastening screws -1-
. See Fig 1.
Tightening torque: See Tightening torques .
- See Installing the rear fabric lining .
Instructions for making distance gauge
Make distance gauge out of wood or plastic according to the specified dimensions A, B, C, D. See Fig 2.
- A = 60 mm
- B = 15 mm
- C = 1.2 mm
- D = 15 mm