Removing the rear fabric lining

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Rear Fabric Lining Components - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

The electrical lead for the sun blind drive is pulled into the rear right fabric lining. In order to replace the fabric lining, the electrical plug connection on the drive motor must be disconnected. See Removing and installing electric motor for sliding roof sun blind - Targa .

REAR FABRIC LINING COMPONENTS REMOVING PROCEDURE - TARGA

No.	Procedure	Instructions
	Removing the front fabric lining	See Removing the front fabric lining .
1	Removing retainer	1. Pull the rubber hose -1- out of the holder. See Fig 1.
		2. Pull the retainer -2- off with pointed-nose pliers. See Fig 1.
		3. Disengage the rear fabric lining -3- from the drive. See Fig 1.
2	Removing lower connection	Pull the fabric lining -3a-direction of arrow- . See Fig 1.
3	Removing top connection	Pull the fabric lining -3b-direction of arrow- . See Fig 1.