Removing left electric motor for sliding roof
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Remove ignition key.
- Always remove only one sliding roof motor. This ensures that the sliding roof does not shift and so avoids the need for a complicated adjustment.
- The sliding roof motor can be removed regardless of the roof position.
- The rear lid can be opened from inside after removal of the rear wall lining, regardless of the roof position. See Sliding roof emergency operation mechanism .
LEFT ELECTRIC MOTOR REMOVING PROCEDURE - TARGA
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Removing rear wall lining | Hold rear cover at the side underneath and carefully pull out of the clips in the -direction of arrow- . See Fig 1. |
| 2 | Folding closing aid over | Unscrew the fastening screws -1-R- . See Fig 1. |
| 3 | Unscrewing the electric motor -4- . See Fig 1. | Undo fastening screws -2- . See Fig 1. |
| 4 | Disconnecting the plug connection | Push up the unlocking lever on the plug connection -3-arrow- . See Fig 1. |
| 5 | Removing the electric motor | Remove the electric motor for the sliding roof -4-5- . See Fig 1. |