Removing cover for sliding roof

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Sliding Roof Cover Components - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

Distance sleeves -4- are calibrated. See Fig 1.
Before removal, mark the installation position.
The distance sleeves vary from 11 - 15 mm.

SLIDING ROOF COVER REMOVING PROCEDURE - TARGA

No.	Procedure	Instructions
	Removing the A-pillar trim	Refer to REMOVING AND INSTALLING A, B AND C-PILLARS - TARGA .
	Removing fabric lining, front	See Removing the front fabric lining .
	Removing electric motor for sun blind	Refer to Removing and installing electric motor for sliding roof sun blind - Targa .
1	Removing front cap	Insert a small screwdriver in the cap -1- . See Fig 1.
2	Unscrewing fastening screws	Unscrew fastening screws -2-3- . See Fig 1.
3	Removing cover for sliding roof	Lift off the cover for the sliding roof -3- . See Fig 1.
4	Marking the spacer sleeves	Mark the installation position of the spacer sleeves -4- . See Fig 1.