Installing cover for sliding roof: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Sliding Roof Cover Components - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

SLIDING ROOF COVER INSTALLING PROCEDURE - TARGA

No.	Procedure	Instructions
1	Positioning spacer sleeves	Position spacer sleeves -4- . See Fig 1.
2	Installing cover for sliding roof	Position the cover for the sliding roof -3- . See Fig 1.
3	Screwing in fastening screws	Screw in fastening screws. -Loctite 243- . See Fig 1.
		Use screw locking lacquer -Loctite 243- . See Fig 1.
4	Installing front cap	Press the front cap -1- . See Fig 1.
	Installing electric motor for sun blind	Refer to Removing and installing electric motor for sliding roof sun blind - Targa .
	Installing side fabric lining	See Installing the front fabric lining .
	Installing A-pillar trim	Refer to REMOVING AND INSTALLING A, B AND C-PILLARS - TARGA .