Installing the front fabric lining

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Front Fabric Lining Components - Targa

Courtesy of PORSCHE OF NORTH AMERICA, INC.

FRONT FABRIC LINING COMPONENTS INSTALLING PROCEDURE - TARGA

No.	Procedure	Instructions
1	Pulling the lower connection	Pull the connection seal of the fabric lining -3- . See Fig 1.
2	Pulling in the top connection	Pull the connection seal into the plastic cover -2-direction of the arrow-dimension X = 6mm- . See Fig 1.
3	Installing the plastic cover	1. Insert the plastic cover -2- at the front into the roof module. See Fig 1.
		2. Insert plastic cover under the metal clip -X- . See Fig 1.
		3. Screw the fastening screw -4- into the plastic cover at the rear. See Fig 1.
4	Fitting the connection	Pull fabric lining to the rear until the plastic cover is covered. Lay the bead around the plastic cover -2-2- . See Fig 1.
5	Installing cover	Push cover -1- . See Fig 1.