LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (74 - Seat UPHOLSTERIES, Cover -- CARRERA (997)) >> WM 740919 Removing And Installing Suction Fan For Seat Surface (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 CARRERA 4 GTS CABRIO, 911 Gt2 RS, 911 Gt3 RS 4.0) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. → 2706IN 00 WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
  2. Remove the front seat. → REMOVING FRONT SEAT
  3. Mount the front seat on the assembly fixture. → 7201IN MOUNTING FRONT SEAT ON ASSEMBLY FIXTURE

    Information 

    Driver's side only:

  4. Remove control unit for memory seat adjustment. → REMOVING CONTROL UNIT FOR MEMORY SEAT ADJUSTMENT

    Information 

    Only for vehicles with weight sensing AWS (USA) on the passenger's seat.

  5. Remove control unit for AWS. → REMOVING AWS CONTROL UNIT
scientia non olet · About LEMON Manuals