LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (64 - Glazing, Window Control -- CARRERA (997)) >> WM 648619 Removing And Installing Rear Window (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 TARGA 4, 911 TARGA 4S, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove C-pillar trim panel at the left and right. → REMOVING C-PILLAR TRIM 
  2. Remove wiper motor for rear window washer. → REMOVING WIPER MOTOR FOR REAR WINDOW WASHER 
  3. Remove rear center panel. → REMOVING REAR CENTER PANEL


  1. Remove hardtop. → REMOVING HARDTOP
  2. Place outer side of hardtop on the assembly fixture.
scientia non olet · About LEMON Manuals