Removing control unit for alarm system

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Control Unit For Alarm System

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE:

Only remove the control unit with the battery disconnected. See WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
Code numbers from IPAS are required.
In order to prevent possible complications when teaching the transponder and radio codes, use the spare key as well.
The control unit for the alarm system can only be taught for one vehicle; a transfer to a different vehicle is not possible.

ALARM SYSTEM CONTROL UNIT REMOVAL PROCEDURE

No.	Procedure	Instructions
	Remove the left front seat
	Refer to REMOVING AND INSTALLING FRONT SEAT, - AS OF MY 1996
1	Opening lock	Open the lock -1-direction of the arrow- . See Fig 1 .
2	Disconnecting the connectors	Press connectors -2- . See Fig 1 .
3	Disconnecting the connectors	Press the locking -arrow-3-4- . See Fig 1 .