LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (55 - Lids, Flaps -- CARRERA (997)) >> WM 559037 Disassembling And Assembling Rear Lid (I-No. XAF) (Turbo Coupe, Turbo CABRIO) >> Disassembling rear lid >> Removing sealing rubber

Removing sealing rubber

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Overview Of Rear Lid
G09824141Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Heat the bonding area of the sealing rubber -1-  using the hot-air blower v.a.g 1416  .
    Fig 2: Identifying Rubber Cover
    G09824142Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Insert a plastic wedge between the rear lid and sealing rubber -1-  and loosen the bonded joint.
  3. Remove adhesive residue on the rear lid using the film eraser Nr.174 Pos.1  and holder Nr.174 Pos.2  .
  4. Remove adhesive residue from the sealing rubber and clean with isopropanol.
scientia non olet · About LEMON Manuals