LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (55 - Lids, Flaps -- CARRERA (997)) >> WM 559037 Disassembling And Assembling Rear Lid (I-No. XAF) (Turbo Coupe, Turbo CABRIO) >> Assembling rear lid >> Installing sealing rubber

Installing sealing rubber

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Clean bonding surface to remove any dust and grease.

  1. Affix adhesive tape to the underside of the sealing rubber -1-  .
    Fig 1: Fitting Rubber Cover
    G09824158Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Pull off protective film and position and stick sealing rubber -1-  on the rear lid as required.
scientia non olet · About LEMON Manuals