LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (55 - Lids, Flaps -- CARRERA (997)) >> WM 558719 Removing And Installing Rear Upper Part Of Lid Lock(All Models) >> Installing rear upper part of lid lock

Installing rear upper part of lid lock

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Installation Position Of Upper Part Of Rear Lid Lock
G09824118Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Position upper part of rear lid lock -2-  and tighten the fastening screws -1-  slightly.
    Fig 2: Installing Rear Upper Part Of Lid Lock
    G09824119Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Adjust upper part of lid lock -2-  in relation to the lid according to the noted position, if necessary, determine left and right gap.
  3. Tighten fastening screws -1-  . → : 9.7 Nm (7.0 ftlb.) 
  4. Check lid function.
scientia non olet · About LEMON Manuals