Removing servo motor for emergency release

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Servo Motor Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Switch off ignition and remove ignition key.
Release electric connector -A- and unplug it at the servo motor.

Fig 2: Removing Plug
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew both fastening screws -1- .

Fig 3: Removing Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Turn the servo motor and disengage the retaining pin from the cable at the servo motor.

Fig 4: Disengaging Cable At Actuating Element
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove servo motor.