Installing servo motor for emergency release

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Engage the cable retaining pin at the servo motor and clip it in.

Fig 1: Engaging Cable On Assembly Servo Motor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position servo motor and secure with the fastening screws. → Tightening torque: 9.7 Nm (7.2 ftlb.)

Fig 2: Screwing Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push electric plug onto the servo motor until it is felt to engage.

Fig 3: Plugging In Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.