Installing switching element for filler flap

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Engage switching element for filler flap into the emergency operation cable.

Fig 1: Engaging Switching Element For Filler Flap Into Emergency Operation Cable
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert switching element for filler flap into the slots on the holder. Ensure that the locking bolt of the filler flap switching element is positioned in the opening of the side section.

Fig 2: Securing Filler Flap Switching Element To Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure the filler flap switching element with the two fastening screws -1- .
Insert the connector until it is felt to engage.

Fig 3: Connecting Switching Element Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check operation of the filler flap switching element.