Measures For Maintaining Long-Term Body Protection: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- After repair work, the standard corrosion-inhibiting coating should only be restored with the corrosion-inhibiting agents approved by the manufacturer. The following points must be observed for body repairs.
- Always apply welding primer to both sides of the welding flange when resistance spot welding.
- Prime repair areas from outside. Prime on both sides in the accessible areas.
- Seal all sheetmetal overlaps, sheetmetal edges, butt joints, weld seams etc. with body sealant.
- When replacing structurally bonded body parts, proceed according to the information in the respective repair instructions.
- Only apply body sealant to primed sheetmetal parts.
- Apply top coat paint to the inside of the outer sheetmetal shell before welding.
- Build up paint on bare sheetmetal panels according to the painting methods described in the → "Paint Service Information ".
- Repair or create standard undersealing by applying long-life undersealing material.
- Preserve cavities in the repair area with cavity preservative after applying a top coat paint.
- Check that the standard water drains (plugs) function correctly or clean them after the cavity preservation material has dried.