Removing Inner Front Side Member
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove the end plate. → 501055 REPLACING END PLATE - section on "Removing"
- Remove floor front section. → 502055 REPLACING FLOOR FRONT SECTION - section on "Removing"
- Remove front wheel housing. → 507455 REPLACING WHEEL HOUSINGS AND SIDE MEMBERS - section on "Removing"
- Separate welded seams.
- 4.1. Separate inert-gas welded seams in area -A-
using a parting grinder.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Separate welded seams.
- 5.1. Separate inert-gas welded seams in areas -A-
and -B-
using a parting grinder.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Separate welded seams.
- 6.1. Separate inert-gas welded seams in area -A-
using a parting grinder.
- 6.2. Separate inert-gas plug welds in area -B-
using a parting grinder.
- 6.3. Separate inert-gas slot welds in area -C-
using a parting grinder.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Mill off spotweld.
- 7.1. Mill off spotweld in area -A-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Mill off spotwelds.
- 8.1. Mill off spotwelds in area -A-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|