Installing Front Wheel Housing Liner - Rear Section

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Push in wheel housing liner toward the outside up to contact in wing stop position.
Ensure that the right wheel housing liner is guided through the opening on the wheel well.

Insert wheel housing liner -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening nuts -1- . → Tightening torque: 2.5 Nm (2 ft. lb.) .
Tighten fastening screws -2- . → Tightening torque: 2.8 Nm (2 ft. lb.) .

Information

Push in wheel housing liner toward the outside up to contact in wing stop position.
Ensure that the right wheel housing liner is guided through the opening on the wheel well.

Insert wheel housing liner -A- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening nuts -1- . → Tightening torque: 2.5 Nm (2 ft. lb.) .
Tighten fastening screws -2- . → Tightening torque: 2.8 Nm (2 ft. lb.) .