Fastening Tank Filler Neck
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Information
- The following points apply only to the right wing.
- Install angled pipe -8-
. Press in the plastic clip -9-
until the locking tabs -B-
engage audibly.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Tighten fastening screw -6-
on tank filler neck -7-
. Tightening torque → Tightening torque: 7.5 ft. lb.
- Press in the locking tabs -A-
of the sleeve -5-
until they engage audibly.