Removing Floor Front Section
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Mill off spotwelds.
- 1.1. Mill off spotwelds applied to the front panel in area -A-
(2 plate thicknesses).
- 1.2. Mill off spotwelds in area -B-
(1 plate thickness).
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Separate spotwelds.
- 2.1. Separate spotwelds applied to the right side member in area -A-
from below.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Separate spotwelds.
- 3.1. Separate spotwelds applied to the left side member in area -A-
from below.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Mill off spotwelds.
- 4.1. Mill off spot welds applied to the front closing panel in area -A-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|