Removing Front Closing Panel
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Milling off spotwelds
- 1.1. Mill off spotwelds in area -A-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Milling off spotwelds
- 2.1. Mill off spotwelds in areas -A, B, C, D-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Milling off spotwelds
- 3.1. Mill off spotwelds in areas -A, B, C, D-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Milling off spotwelds
- 4.1. Mill off spotwelds in areas -A, B, C, D-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Separating spotwelds
- 5.1. Separate spotwelds in areas -A-
and -B-
using a parting grinder.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
- Milling off spotwelds
- 6.1. Mill off spotwelds in areas -A, B, C, D, E, F-
using a spotweld cutter.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|