Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install intake-air distributor.
→ 244619 REMOVING AND INSTALLING INTAKE-AIR DISTRIBUTOR .
Install resonance tube.
→ 247419 REMOVING AND INSTALLING RESONANCE TUBE .
Install air cleaner housing.
→ 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING .
Use PIWIS Tester 9718 to bleed the high-pressure system using the First Start function.
Perform a test drive. A high-pressure adaptation is only necessary if the high-pressure pump has been replaced.
→ 247019 REMOVING AND INSTALLING DME (DFI) CONTROL UNIT .