Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Fit ignition coils. Fit and tighten one internal Torx (T30) countersunk screw (M6 x 16) on each.
→ 282019 REMOVING AND INSTALLING IGNITION ROD MODULE .
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- Fit heat shield for ignition coils.
→ 261219 REMOVING AND INSTALLING HEAT SHIELD .
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- Fit exhaust manifolds with a new seal. Insert and tighten nine screws (M8 x 21) on each.
→ 261019 REMOVING AND INSTALLING EXHAUST MANIFOLD WITH CATALYTIC CONVERTER .
→ Tightening torque: 23 Nm (17 ft. lb.)
- Fit holder for rear silencer.
- 4.1. Fit and tighten four M8 external Torx screws.
→ Tightening torque: 23 Nm (17 ft. lb.)
- 4.1. Fit and tighten four M8 external Torx screws.
- Install rear silencer.
- Install engine.