Installing Optical Contacts On Connector Side

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Remove the dust boot right before plugging.

Check the proper condition of the contacts.

Push optical contacts -A and B- into the connectors until they engage securely.
1. Optical contact, grey
2. Optical contact, black
Fig 1: Locking Primary Locking Mechanism Of Optical Contacts (Connector Side)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Close the secondary locking mechanism and check that the optical contacts are seated securely.

Fig 2: Locking Secondary Locking Mechanism Of Optical Contacts (Connector Side)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.