Removing Wire Harness For Rear Spoiler

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Open the rear lid.
Release the locking lug -1- for the electric plug connection -arrow A- and disconnect it -arrow B- .

Fig 1: Disconnecting Wire Harness At Rear Lid
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Open the wiring duct -arrow A- and take out the line -arrow B- .

Fig 2: Loosening Line On Hinge For Rear Lid
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unplug electric connector for engine-compartment scavenging blower

Fig 3: Removing Electric Line At Engine-Compartment Scavenging Blower
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. Release the connector -arrow A- and pull it off -arrow B- .
2. 4.2. Take the line out of the holder -arrow C- .
Unclip line from rear lid at two places.
Pull wire harness out through the openings at the rear lid.