Completing The Vehicle

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Insert insulating elements in the area of the rear wire harness.
Install mounting saddle for rear-seat backrest.

Fig 1: Installing Mounting Saddle For Rear-Seat Backrest
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Position mounting saddle for rear-seat backrest -2- and secure with the two fastening screws -1- . → Tightening torque: 10 Nm (7.5 ft. lb.)
Install left and right support.

Fig 2: Engaging Support
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Position the support and engage in lower side member.
2. 3.2. Push in the locating peg -1- of the support and check that it is seated correctly.
  
  Fig 3: Securing Support
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 3.3. Tighten the fastening nuts -3- and fastening screws -2- . → Tightening torque: 7.2 Nm (5.5 ft. lb.)
Lay the floor covering over the support and engage.
Information

Ensure that belt strap can run properly!
Secure seat belt mount at left and right.

Fig 4: Installing Seat Belt
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 5.1. Screw in fastening screw -2- , seat belt and fitting -3- and spacer sleeve -4- on inner lower side member. → Tightening torque: 50 Nm (37 ft. lb.)
2. 5.2. Press in cap -1- .
Install left footwell trim panel.

Fig 5: Installing Lateral Footwell Trim On Driver Side
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 6.1. Insert footwell trim panel -3- (-arrow A- ) and screw in the three fastening screws -2- . → Tightening torque: 3 Nm (2 ft. lb.)
2. 6.2. Insert the fuse carrier cover -1- with both clips -4- into the lateral footwell trim panel -2- and clip in -arrow B- .
Install right footwell trim panel.

Fig 6: Installing Lateral Footwell Trim On Passenger Side
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 7.1. Position footwell trim panel -3- (-arrow A- ) and screw down with both plastic nuts -2- .
2. 7.2. Secure floor covering -1- at the bottom in the area of the A-pillar -arrow B- . Use double-sided adhesive tape or suitable adhesive .