Exposing Main Wire Harness In Passenger Compartment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Loosen seat belt mount at left and right.

Fig 1: Loosening Seat Belt Screw
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Press off cap -1- with a screwdriver and unscrew the fastening screw -2- . Remove seat belt with fitting -3- and spacer sleeve -4- .
Disengage floor covering at the support and lay it in the vehicle interior.
Remove left and right support.

Fig 2: Removing Peg Of Support
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Unlock locating peg -1- of the support using the commercially available disassembly tool Disassembly Tool, Universal Nr. 21 .
2. 3.2. Unscrew fastening screws -2- and nuts -3- and carefully pull the support up and out of the retaining points.
  
  Fig 3: Locating Fastening Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.