Completing The Vehicle

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install left and right support.

Fig 1: Engaging Left And Right Support
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Position the support and engage in lower side member.
2. 1.2. Press in the locating peg -1- of the support and check it is seated correctly.
  
  Fig 2: Securing Support
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 1.3. Tighten the fastening nut -3- and fastening screws -2- . → Tightening torque: 7.2 Nm (5.5 ft. lb.)
Lay the floor covering over the support and engage.
Information

Ensure that belt strap can run properly!
Fasten seat belt mount at left and right.

Fig 3: Installing Seat Belt
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 3.1. Tighten fastening screw -2- , seat belt with fitting -3- and spacer sleeve -4- on inner lower side member. → Tightening torque: 50 Nm (37 ft. lb.)
2. 3.2. Press in -1- cap.