LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (97 - Cables -- CARRERA (997)) >> WM 9700IN Measurement Of Closed-Circuit Current (All Models) >> Measurement Of Closed-Circuit Current >> Preliminary Work On Vehicle

Preliminary Work On Vehicle

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Before measuring the closed-circuit current, determine the vehicle equipment (I numbers) and establish the expected closed-circuit current with the aid of the attached table.

  1. Open the front luggage compartment.
  2. Using a suitable tool, e.g. upper part of lock with a suitable handle, close lower part of luggage compartment lock while keeping the luggage compartment lid open.
  3. Remove ignition key, close doors and rear lid, do not lock  vehicle.
  4. Set the measuring instrument to the highest possible current-measuring range.
  5. With two alligator clips, connect the measuring instrument to the battery ground and to the unoccupied second body ground which is always available for RHD or LHD.
  6. Remove ground strap from the body and secure against contact with the body. The entire vehicle current now flows through the ammeter.
scientia non olet · About LEMON Manuals