Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Replace O-rings on the relevant intake manifold and grease lightly with Kluber Syntheso Glep.
Fix intake manifold in place on the support in the engine compartment and then fit it on the turbocharger flange.
1. 2.1. Cylinder bank 1-3: fit and tighten two M6 Torx screws -arrows- on the turbocharger and one M6 hexagon nut -1- on the guide plate.
  
  Fig 1: Identifying Intake Manifold Flange 1-3
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 2.2. Connect cable plug on electronic adjuster.
3. 2.3. Cylinder bank 4-6: Fit and tighten two M6 Torx screws -arrows- on the turbocharger.
  
  Fig 2: Identifying Intake Manifold Line And Electronic Adjuster Connector 4-6
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. 2.4. Connect cable plug -1- on electronic adjuster.
  → Tightening torque: 10 Nm (7.5 ft. lb.)
Install rear silencer → 263319 REMOVING AND INSTALLING REAR SILENCER .
Install charge air cooler → 214319 REMOVING AND INSTALLING CHARGE AIR COOLER .