Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Oil pressure line on turbocharger | Internal Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Lines on turbocharger | External and internal Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Oil pressure line, upper | Internal Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Holding clamp and ground strap | External Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Heat shield | External Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Solenoid hydraulic valve to cylinder head | External Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Oil pressure line on turbocharger | Internal Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Lines on turbocharger | External and internal Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Ignition coil | Internal Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Holding clamp | External Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Heat shield | External Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) | ||
| Intake air line to turbocharger | External Torx screw, M6 | Tightening torque | 10 Nm (7.5 ft. lb.) |