Installing Oil Pressure Line - Cylinder Bank 4-6
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Guide in oil pressure line.
- 1.1. Protect the sealing flanges of the oil pressure line from damage using a stopper.
- 1.2. Do not remove stoppers until just before fitting.
- Apply a light coating of Kluber Syntheso Glep on the bores for the oil pressure line on the turbocharger and cylinder head.
- Install turbocharger for cylinder bank 4-6.
→ 213019 REMOVING AND INSTALLING TURBOCHARGER - GT2 RS .
Information
- Lightly grease the O-rings on the three outer lines on the turbocharger using Kluber Syntheso Glep only.
- The O-rings on the oil pressure lines must not be greased. Only apply a light coating of Kluber Syntheso Glep on the bore in the turbocharger.
Information
We recommend that you use the following tools to secure the internal Torx screw (oil pressure line) on the turbocharger:
- Torx screwdriver insert bits Nr.41 (Hazett 2223 lg T30).
- Change-over ratchet insert bit Nr.186 (Hazett 6408).
- Torque wrench Nr.90 Pos.2.
- First fit the oil pressure line on the turbocharger, then on the cylinder head.
- 4.1. Fit the M6 internal Torx screws by hand and tighten them.
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- 4.1. Fit the M6 internal Torx screws by hand and tighten them.
- Remove stoppers on the coolant lines before fitting to allow remaining coolant to drain away.
- Attach the other three lines to the turbocharger with new O-rings.
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- Install ignition coil for cylinder 5. Fit and tighten two M6 internal Torx screws.
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- Fit holding clamp -2-
for oil pressure line -1-
on the camshaft housing cover. Fit and tighten one M6 Torx screw.
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- 8.1. Connect ignition coil plug for cylinders 4 and 5 -3- .
- 8.2. Connect cable plug for hall sender -4- .
- Fit heat shield. Fit and tighten two M6 Torx screws.
→ Tightening torque: 10 Nm (7.5 ft. lb.)