Installing Electronic Adjuster - Cylinder Bank 4-6

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Before installing the electronic adjuster, press the new actuating rod onto the ball joint of the removed electronic adjuster.
Information

Specifications for wrench sizes (a/f specifications) for screw heads are described as follows:
- Torx screws: (E..) for external Torx, (T..) for internal Torx.
- Hexagon-head bolts (internal and external hexagon): Wrench size (a/f)
Fit cheese head bolt (hexagon socket a/f 5, M6 x 30) at the top -2- on the electronic adjuster.
Tool recommendation as for removal

Fig 1: Identifying Electronic Adjuster For Turbocharger, Cylinder Bank 4-6
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Using tools:

Fig 2: Installing Electronic Adjuster For Turbocharger
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit and tighten two cheese head bolts (hexagon socket a/f 5, M6 x 30) -1- on the electronic adjuster.
→ Tightening torque: 7 Nm (5 ft. lb.)

Tool recommendation as for removal

Fig 3: Identifying Bottom Fastening Screws On Electronic Adjuster, Cylinder Bank 4-6
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten the third cheese head bolt on the electronic adjuster -> Tightening torque: 7 Nm (5 ft. lb.) .
Tool recommendation as for removal
Press the ball joint of the new actuating rod -1- onto the turbocharger.

Fig 4: Pressing Ball Joint Of Actuating Rod Onto Turbocharger
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect cable plug on the electronic adjuster.