Installing Electronic Adjuster - Cylinder Bank 1-3

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Before installing the electronic adjuster, press the new actuating rod onto the ball joint of the removed electronic adjuster.
Information

Specifications for wrench sizes (a/f specifications) for screw heads are described as follows:
- Torx screws: (E..) for external Torx, (T..) for internal Torx.
- Hexagon-head bolts (internal and external hexagon): Wrench size (a/f)
Fit and tighten cheese head bolts (hexagon socket a/f 5, M6 x 30) -2- on the electronic adjuster.
Tool recommendation as for removal

→ Tightening torque: 7 Nm (5 ft. lb.)

Fig 1: Installing Electronic Adjuster For Turbocharger, Cylinder Bank 1-3
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Using tools → Loosening/securing electronic adjuster on cylinder bank 1-3

Fig 2: Loosening/Securing Electronic Adjuster On Cylinder Bank 1-3
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the ball joint of the new actuating rod -1- onto the turbocharger.

Fig 3: Pressing Ball Joint Of Actuating Rod Onto Turbocharger
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit cover -1- for electronic adjuster and intake air line.
1. 4.1. Fit and tighten two external Torx screws (E10, M6 x 30) -2- on the turbocharger.
  → Tightening torque: 10 Nm (7.5 ft. lb.)
  
  Fig 4: Identifying Electronic Adjuster Cover, Cylinder Bank 1-3
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect the cable plug for electronic adjuster and slide on rubber cap -1- .

Fig 5: Connecting Cable Plug For Electronic Adjuster
Courtesy of PORSCHE CARS NORTH AMERICA, INC.