Installing Electronic Adjuster For Turbocharger, Cylinder Bank 4-6

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Replace the actuating rod for the adjustment mechanism after removing the electronic adjuster.

Fit the new actuating rod on the ball joint of the removed electronic adjuster before installing the electronic adjuster.
Insert electronic adjuster with actuating rod. Guide actuating rod to the ball joint on the turbocharger.
Secure electronic adjuster.
Tool recommendation: see removal details.
1. 3.1. Fit one fastening screw with washer (hexagon socket a/f 5, M6 x 26) -2- at the top of the electronic adjuster, but do not tighten yet.
  
  Fig 1: Inserting Electronic Adjuster With Actuating Rod
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 3.2. Fit two fastening screws (hexagon socket a/f 5, M6 x 26) -2 and 3- at the bottom of the electronic adjuster, but do not tighten yet.
3. 3.3. Fit ball joint of actuating rod on turbocharger -1- .
  
  Fig 2: Fitting Ball Joint Of Actuating Rod On Turbocharger
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten cheese head bolts with washer (hexagon socket a/f 5, M6 x 26) on electronic adjuster.
→ Tightening torque 8 Nm (6 ft. lb.), same as bank 1-3
Connect cable plug on electronic adjuster -1- .

Fig 3: Connecting Cable Plug On Electronic Adjuster, Cylinder Bank 4-6
Courtesy of PORSCHE CARS NORTH AMERICA, INC.