Installing Charge-Air Cooler

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position the charge -air cooler module on two threaded bolts on the body.
Use two hexagon-head bolts (M8 x 16) -left arrows- and one M8 hexagon nut -top right arrow- to secure the charge-air cooler bracket in the wheel housing.

Fig 1: Locating Charge-Air Cooler Bracket In Wheel Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position the bracket on the rear side using one hexagon-head bolt (M8 x 16) -2- and one M8 hexagon nut -1- , then tighten all threaded joints. → Tightening torque: 23 Nm (17 ft. lb.)

Fig 2: Identifying Rear Side Hexagon-Head Bolts (M8 x 16)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Use two speed nuts (a/f 13) -arrows- to secure the heat protection panel to the underside of the charge-air cooler bracket.

Fig 3: Locating Speed Nuts On Rear Heat Protection Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pre-fit the spring clamps for suction and pressure hoses on the charge-air cooler.
Replace O-rings on suction and pressure hoses if necessary and grease them with Kluber Syntheso Glep (available from Porsche Parts Service).
Insert suction and pressure hoses into the rapid-action couplings on the charge-air cooler.
1. 7.1. The connection must engage audibly. Pull to check that the connection is secure.