Component overview

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Component Overview Of Pressure Pipe

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressure pipe
Pressure hoses from charge air cooler
Rubber shroud for pressure system

Remove pressure pipe.
1. 1.1. Disconnect and pull off the ambient air lines -1- at the left and right of the pressure pipe.
2. 1.2. Disconnect and pull off the cable plug -2- on the pressure sensor.
3. 1.3. Disconnect and pull off the control lines on the pressure pipe -3 and 4- .
4. 1.4. Loosen the screw-type clamp on the rubber shroud -5- for the throttle unit.
  
  Fig 2: Identifying Pressure Pipe Connections
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. 1.5. Loosen screw-type clamps -1- on the pressure pipe (charge air cooler connection).
  
  Fig 3: Pulling Pressure Pipe Out Of Rubber Mountings On Air Cleaner Housing
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. 1.6. Pull the pressure pipe out of the rubber mountings on the air cleaner housing -2- and remove it along with the rubber shroud.