LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (21 - Exhaust Gas Turbocharging -- CARRERA (997)) >> WM 214119 Removing And Installing Pressure Pipe (Gt2 RS) >> Information >> Removing Pressure Pipe

Removing Pressure Pipe

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove pressure pipe.
    1. 1.1. Pull cable plug off the boost-pressure sensor -3-  .
    2. 1.2. Loosen screw-type clamps -6-  and pull hoses off the charge air cooler on the pressure pipe.
    3. 1.3. Loosen screw-type clamp -2-  on throttle housing and pull pressure pipe out of the rubber mountings and remove it.
      Fig 1: Identifying Boost-Pressure Sensor, Screw-Type Clamps
      G09828340Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove air cowl.
    1. 2.1. Loosen screw-type clamp and pull air cowl off the throttle housing.
scientia non olet · About LEMON Manuals