Installing Air Guide For Charge Air Cooler

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Guide the air guide through the wheel housing to the air intake and position it.
1. 1.1. Make sure not to damage the rubber lip on the air guide at the air intake.
  Information
  
  Specifications for wrench sizes (a/f specifications) for screw heads are described as follows:
  - Torx screws: (E..) for external Torx, (T..) for internal Torx.
  - Hexagon-head bolts (internal and external hexagon): Wrench size (a/f)
Fit the cover.
1. 2.1. Screw in and tighten ten hexagon-head bolts (a/f 10, M6 x 18) -1- on the air guide in the wheel housing.
  → Tightening torque: 10 Nm (7.5 ft. lb.)
2. 2.2. Screw in and tighten one M6 hexagon nut (a/f 10) -2- .
  → Tightening torque: 3 Nm (2 ft. lb.)
3. 2.3. Screw in and tighten one M8 hexagon nut (a/f 13).
  → Tightening torque: 23 Nm (17 ft. lb.)
  
  Fig 1: Identifying Air Guide Bolts And Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in and tighten seven tapping screws -arrows- for the air guide on the air intake.
→ Tightening torque: 3 Nm (2 ft. lb.)

Fig 2: Locating Air Intake For Charge Air Cooler Tapping Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.