Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Knock sensor for cylinder bank 1-3 |
External Torx screw, M8 x 35 |
Tightening torque |
23 Nm (17 ft. lb.) |
|
|
| Knock sensor for cylinder bank 4-6 |
External Torx screw, M8 x 35 |
Tightening torque |
23 Nm (17 ft. lb.) |
|
|
| Fuel line holder |
External Torx screw, M6 x 12 |
Tightening torque |
10 Nm (7.5 ft. lb.) |
|
|
| Fuel line holder |
External Torx screw, M6 x 45 |
Tightening torque |
10 Nm (7.5 ft. lb.) |
|
|
| Engine carrier to engine mounting |
Special M12 nut (internal Torx, T55) |
Tightening torque |
85 Nm (63 ft. lb.) |
|
|
| Location |
Description |
Type |
Basic value |
Tolerance 1 |
Tolerance 2 |
| Knock sensor for cylinder bank 1-3 |
External Torx screw, M8 x 35 |
Tightening torque |
23 Nm (17 ft. lb.) |
|
|
| Knock sensor for cylinder bank 4-6 |
External Torx screw, M8 x 35 |
Tightening torque |
23 Nm (17 ft. lb.) |
|
|
| Fuel line holder |
External Torx screw, M6 x 12 |
Tightening torque |
10 Nm (7.5 ft. lb.) |
|
|
| Fuel line holder |
External Torx screw, M6 x 45 |
Tightening torque |
10 Nm (7.5 ft. lb.) |
|
|
| Engine carrier to engine mounting |
Special M12 nut (internal Torx, T55) |
Tightening torque |
85 Nm (63 ft. lb.) |
|
|