Subsequent Work
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Install upper part of heat shield.
→ 261219 REMOVING AND INSTALLING HEAT SHIELD .
- 1.1. Fit heat shield and screw in and tighten two M6 x 12 outer Torx screws (socket insert E10).
→ Tightening torque: 10 Nm (7.5 ft. lb.)
- 1.1. Fit heat shield and screw in and tighten two M6 x 12 outer Torx screws (socket insert E10).
- Install rear silencer.
- Mount rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.